End mill holder Weldon SK 50 - 20 - 63Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

- Instruction manual

with wrench

Heat-treated steel

set contains following adaptors:

Easy to read dial face

PSK = PSK 50

Dial face dia

For mini clamping nuts ER-system

bei Ø 6 – Ø 32 mm = h236

- Tightness of the screw connection tested up to 80 bar

For mounting tools with straight shanks

- Wooden box